A Controller Area Network is a robust vehicle bus standard designed to allow microcontrollers and devices to communicate with each other in applications without a host computer.

Найняти Embedded Engineers

Фільтрувати

Мої недавні пошуки
Фільтрувати по:
Бюджет
до
до
до
Тип
Навички
Мови
    Статус роботи
    6 робіт знайдено, ціни вказані в USD

    Development of firmware for an LED indicator lamp with CANOpen communications. Code has already been developed for controlling LEDs via a LP5036 IC. The goal of the current project is toreplace the LP5036 with strip of 60 WS2813. --Hardware-- - MCU is the STM32F042K6T7 (Can use NUCLEO-F042K6 for development) - LED IC is WS2813B (Can use WS2812 breakout/strip for development) - Interfaces are CAN ...

    $583 (Avg Bid)
    $583 Сер. заявка
    5 заявки
    PLC Project 5 дні(-в) left
    ПІДТВЕРДЖЕНО

    I have a few projects with PLC. I want to with an expert, so I can finish them perfectly. I will provide all data with an expert. If you are an expert in PLC and Micro controller, Plz bid on this project.

    $441 (Avg Bid)
    $441 Сер. заявка
    40 заявки
    code for arduino/raspberry CANBUS automotive message substitution 13 годин(-и) left
    ПІДТВЕРДЖЕНО

    Need code for raspberry Dual CANBUS Port > CAN Bridge Standard to Custom PIDS .

    $604 (Avg Bid)
    $604 Сер. заявка
    16 заявки
    arduino/raspberry CANBUS automotive protocol OBD II SAE J1979 11 bit 13 годин(-и) left
    ПІДТВЕРДЖЕНО

    Need code for raspberry Dual CANBUS Port > CAN Bridge Standard & Custom PIDS .

    $187 (Avg Bid)
    $187 Сер. заявка
    7 заявки

    Need code for raspberry with dual CANBUS board to do the following bridge standard pids & customs pids: CAN PORT 1 > Receives queries Service 1 Standard PIDS from a elm327 based interface CAN PORT 2 > Queries OBD car port equivalent custom pid (CAN 11 format 7E8n) and replys to CAN PORT1 (standard PID) EXAMPLE: " audi 2.0tdi have Exhaust temperature sensors BUT ecu dont reply to ...

    $279 (Avg Bid)
    $279 Сер. заявка
    4 заявки
    ELM327 CANBUS service 1 Pids to CAN (11-bit) bus format 9 годин(-и) left
    ПІДТВЕРДЖЕНО

    Need a windows aplication to do the bridge/translation communications rs232 AT commands between my Elm 327 based software and the car OBD CANBUS Connector. Example: My software query service 1 PID 01 01 to a virtual port, then the developed software will query the car equivalent PID on Can (11bit) bus 7e8h adress and answers to my software virtual port.

    $313 (Avg Bid)
    $313 Сер. заявка
    6 заявки