Hello I have already build a robot that follow a line using raspberry pi3, ubunut 16 and ROS kinetic. But the robot is very slow and reacting very slowly. It takes some time before it understand that it need to turn. I accept two solutions: 1)Either you help with finding the bugs in the code that makes the raspberry pi camera run much faster. Or 2)You help with running the robot with raspberry pi 4, ROS noetic and ubuntu 20 Because I am using raspberry pi 3, ubuntu 16 and ROS kinetic. All these are slow. Please do not waste my time and your time. Apply to this work if you have the enough experience to do at least one of the points above and have already done it a few times before. Regards Jony
There is a request from an HR company to create a process that would help with picking the best match applicants for specific jobs. There is a mapping file used to match required skills and experience to each job type. The CVs are sent via email and there are three accepted formats. Each incoming CV goes into a job specific folder. The documents should be classified and then the relevant information such as skills and experience should be extracted. After the data is extracted from the document, a formula is applied to determine how fit is the candidate for the desired position and in the end, a list with the top 10 candidates for each job is sent over email.
Robotic arm from Ufactory need to program to receive order from kiosk and start working on the order required python skill and robotic arm experience who based in Sydney
I want a robotic arm with 30 degree swivel. The arm consists of two parts, upper and lower. the connection between these two can be a ball to enable the swivel with 30 degree or any other mechanical part that can enable swivel. the upper arm at the end should have a piston technology, that can be controlled by a controller in the unit, for now the piston can be set to manual up and down with adjustable speed button.