Beckhoff twincat and twinsafe motion control

$750-1500 USD

Завершено

Опублікований

over 10 years ago

$750-1500 USD

Оплачується при отриманні

Hello I am looking for someone who can program a Beckhoff PLC 5020-0112 to position 4 - 16 Drives (Beckhoff AX5000 or SEW movidrive with Ethercat options module) point to point using absolute encoder feedback. E-stop to be programmed on Twinsafe I would then need a HMI where i can move each drive to the desired position either individually or in groups. It must be possible to set the speed, position ,and acceleration for each movement and it must be possible to program (n) movements. Peter McKenzie

PLC & SCADA

Software Architecture

ID проекту: 5065864

Про проект

3 пропозицій(-ї)

Дистанційний проект

Активність 10 yrs ago

Хочете заробити?

Переваги подання заявок на Freelancer

Вкажіть свій бюджет та терміни

Отримайте гроші за свою роботу

Опишіть свою пропозицію

Реєстрація та подання заявок у проекти є безкоштовними

Доручений:

@Aleksandarvr

Hello, I am still interested for this job. I just need more detail information from you. Experience: Codesys 2, TwinCAT 2, Motion Control, ... All the best! Aleksandar

$998 USD за 15 дні(-в)

0,0

(0 відгуки(-ів))

0,0

3 фрілансерів(-и) готові виконати цю роботу у середньому за $1 073 USD

@melsayedhasan

Hello, My name is mohamed, TA at faculty of engineering , cairo university . I have a master degree in control systems .I'm also working on an automation company where i deal with different PLC and SCADA applications like Schneider, Siemens and AB .I program many projects with Siemens and Schneider drives . I noticed that it's not first time to post this project so i need to help even if i don't use your drives. Don't pay till you are satisfied

$1 111 USD за 15 дні(-в)

4,8

(5 відгуки(-ів))

3,5

@dinhnamluong

Dear Sir. I have more experience in similar projects like this. I believe I can help you complete this project. Best regard ! Luong Dinh Nam.

$750 USD за 15 дні(-в)

0,0

(0 відгуки(-ів))

0,0

@khadorik

Hello. I can program PLC and create HMI in Beckhoff HMI like in your picture. I have question about E-Stop. Do you want use E-Stop for each servodrives or use one E-Stop for all servodrives?

$1 110 USD за 14 дні(-в)