Design Microcontroller Code
$30-250 AUD
Оплачується при отриманні
Devise a communication protocol/method to communicate to between devices, through RS232. There is one ‘master’ and up to two slaves, which communicate two ways. Slaves will have unique addresses. Code needs to be compatible with ATMEL microcontrollers as this is what will be used.
Communication is simple and will take the following form;
• Master to slave
o Turn output 1 to 8 high/low
• Slave to master
o Status of X input is high/low
The command sent may have some form of character identification to determine the type of command sent, before having input/output identification and then finally high/low status.
Example:
• OUTXY
o Where “OUT” is output command from master to slave
o X is output number
o Y is high/low status
• FUSXY
o Where ‘FUS” is input status from slave to master
o X is input number
o Y in high/low status
ID Проекту: #15669172
Про проект
24 фрілансерів(-и) готові виконати цю роботу у середньому за $187
Hi I hope you are doing well. I have expertise in AVR Micro controller programming and RS232 communication. I have understood your project requirements and I have few questions regarding your project. Looking Forw Більше
I can code this communication protocol. I have worked on uart, I2C , SPI and many other communication protocols. Relevant Skills and Experience Electrical engineering Proposed Milestones $200 AUD - required work
i have been completed many project on Atmel controller and you can it in my review. so i can do your job.
Hello, Deep is here from India. Basically I'm Embedded System Developer. I understand your requirement. I have experience with ATMEL microcontrollers (Atmega8-16-32-328-128-2560, XMega, ATtiny). Basically UART protoc Більше
I Believe it's simple I/O expander Relevant Skills and Experience I have experience in ATMEGA Processors use Assembly, C, and Arduino Code depending on situation Proposed Milestones $83 AUD - Complete As i said befo Більше
Hello, I am a professional designer of data acquisition and control systems (both hardware and programming, including AVR microcontrollers & Arduino), and I could help you with your design. Relevant Skills and Experie Більше
I have more than 10 years of en experience in the digital design and in the interface protocols of course. So I can do this task well. Соответствующие навыки и опыт FPGA/ASIC design, Verilog/VHDL design, The sufficien Більше
Can provide code for your project Relevant Skills and Experience Long experience in embedded programming, check our portfolio for a sample of our work Proposed Milestones $45 AUD - Completion Additional Services Off Більше
i have a good knowledge about microcontroller programming and have done number of projects using microcontroller .i have worked on number of sensors and modules and soon. Relevant Skills and Experience 4 year of exper Більше
I have 6 years experience in designing circuits of pic controller..where in various projects I used serial port as rs422 and rs232..I used ports to send data to PC by usb also, and I m pretty sure that I can deliver th Більше
Use UART to design communication link between a master slave daisy chain to poll slave uC and check Pin/Port input status Relevant Skills and Experience Embedded Systems designer, Atmel AVR assembly and C designer Pr Більше
Communication Protocol, development is required. That's what we understand, if not please elaborate more with details. Relevant Skills and Experience We have developed several communication protocol. Proposed Milesto Більше
Hello, thank you for the opportunity to bid on your project! I have written several master/slave implementations that work over RS232. Relevant Skills and Experience Your project has special hardware requirements whic Більше