Linux Device Driver(repost)

Determine the changes to UART.c required to work in RS-485 mode. It currently works in RS-232 mode. I need SCC3 to work at a baud rate of 128K and SCC4 to work at a baud rate of 256k. This can be done in int __init rs_8xx_init(void), you can program the values into the BRG(baud rate generator) and connect to the channels. Set up I/O by programming the ports as outputs and initializing the values. I need this program to work in synchronous mode. It currently works in asynchronous mode. Tell me what the changes are that are needed to work in RS-485 mode then do the changes to the program. ## Deliverables 1) Complete and fully-functional working program(s) in executable form as well as complete source code of all work done. 2) Deliverables must be in ready-to-run condition, as follows? (depending on the nature? of the deliverables): a)? For web sites or? other server-side deliverables intended to only ever exist in one place in the Buyer's environment--Deliverables must be installed by the Seller in ready-to-run condition in the Buyer's environment. b) For all others including desktop software or software the buyer intends to distribute: A software? installation package that will install the software in ready-to-run condition on the platform(s) specified in this bid request. 3) All deliverables will be considered "work made for hire" under U.S. Copyright law. Buyer will receive exclusive and complete copyrights to all work purchased. (No GPL, GNU, 3rd party components, etc. unless all copyright ramifications are explained AND AGREED TO by the buyer on the site per the coder's Seller Legal Agreement). ## Platform Linux