Tekla Automation - 5x5mm snipes reqd

Hello, I just saw your project so I can do this type of project very quickly because I have done this type of project so come on the chat for further discussion Thanks

Hello! I am not a Tekla macro expert yet, so I'll be honest, at the moment I don't know exactly how to do your requirement. I just started a job here in Mexico where I have been making some automated reports in Tekla and so far so good. I am really good at making macros though, for several software (AutoCad, SolidEdge ST, excel and so on). That's why I am sure I can achieve this within a few days. However I do need a couple of days for the learning curve. If your project is urgent, I totally understand if you give it to someone else. If you are willing to give me a shot, I will give it my best and work untill the project is done and you are happy with the result. Thanks!

Hello, I can help you with this project, I can make this macro but i will need more information wich we can discuss over chat

Dear sir, I would like to do this job,Have more than five years of experience in structural design and detailing. Highly experienced in site management, structural designing and detailing. Am using STAAD PRO and CSC-FASTRAK for designing and tekla structures for detailing . Please go through my profile. Kindly send the files and award the project to start my work as early as possibly . Proposed Milestones $250 USD - 3days Thanks and regards, jeemon v g

making 5x5 snipe on any plate is possible thru Custom Component. I already made for stiffener edges. the same component can use any where . component made in TS V19, so you can use TS V19 and above