Data acquisition MSP430F5529

Закрито Опубліковано %project.relative_time Оплачується при отриманні
Закрито Оплачується при отриманні

Greetings,

There is an opportunity to develop firmware for data acquisition on a TI's MSP430F5529 (Launchpad development board) micro controller. The characteristics of the system should be as follows:

PWM signal: A PWM signal will be used as a switch for an external circuit, I would need to be able to set a desired frequency as well as duty cycle.

ADC conversion: Conversion on demand from 2 different channels (rapidly one after the other) from the 12 bit internal adc and stored in 16 bit registers.

UART: the two values from the adc must be sent through the UART protocol. A data packet will be formed with the two values (probably separated by commas and ending with a semicolon, to discuss).

When turned on: The uc will receive (UART) these commands: a) START (starts conversion and transmission of digital data through UART) b) STOP (stop conversion), c) PWM_FREQ (set frequency of a PWM signal), d) PWM_DUTY (set duty cycle of the pwm signal), e) SAMPLE_FREQ (set sample frequency of arc conversion).

Thank you for your time.

Програмування на С Мікроконтролер

ID Проекту: #5731275

Про проект

13 заявок(-ки) Дистанційний проект Остання активність May 4, 2014

13 фрілансерів(-и) готові виконати цю роботу у середньому за $217

Hafeez143

A proposal has not yet been provided

$200 CAD за 3 дні(-в)
(8 відгуків(и))
5.8
bulgar

Dear Sir, We specialize in developing Embed systems based Microchip (PIC), Atmel (AVR) and TI (MSP430) MCPUs and peripheries. Our priorities and decisions are Energy harvesting MSP430 based devices. We realize pro Більше

$900 CAD за 7 дні(-в)
(7 відгуків(и))
5.3
designvin

Hello, I have a long experience in hardware and software product development. I have used controllers and processors from Microchip, TI, Atmel, Analog Devices, Freescale etc I have included the cost and delivery time Більше

$222 CAD за 15 дні(-в)
(6 відгуків(и))
4.1
enthuvikas

Hi, greetings. well It will take three working days as soon i receive this board from you to complete this task otherwise you will have to do side by side debugging at you place while I am writing the code. alternative Більше

$155 CAD за 3 дні(-в)
(1 відгук)
3.7
umarghaffar

hi i can do it for you. I am an electronics design engineer and have vast experience of programming the different microcontrollers including MSP . Please reply to discuss the further. Give me a chance to prove my self Більше

$155 CAD за 5 дні(-в)
(3 відгуків(и))
3.3
valeriansarbu

I would like to help with this device and will probably finnish the project by tomorrow if not tonight. Will keep posted and send binaries when ready. Sincerely, Valerian Sarbu

$111 CAD за 2 дні(-в)
(0 відгуків(и))
0.0
Giovanni2G

hi I am a telematic engineer. I already done this project (DCODE for automotiv inverter )but with ARM core microcontroller, but I know also MSP430.

$255 CAD за 5 дні(-в)
(0 відгуків(и))
0.0
EleicsDesign

We are an Electronics Design House Based at India,working on TI,Renesas ,Microchip ,Nuvoton and Other Chips. We can Help you for defining the specification and fulfil your exact need by developing robust software. Більше

$200 CAD за 15 дні(-в)
(0 відгуків(и))
0.0
lbchanjr

A proposal has not yet been provided

$222 CAD за 15 дні(-в)
(0 відгуків(и))
0.0
arka144

i am highly skilled with embedded system ,, know everything bsaout market available microcontrollers

$34 CAD за 4 дні(-в)
(0 відгуків(и))
0.0
kevinloc90

hi. i did a lot of projects with MSP430 MCU. i think i can do what you want to do for your project in my professional. you can trust me!

$55 CAD за 3 дні(-в)
(0 відгуків(и))
0.0
Nanosoft9

A proposal has not yet been provided

$111 CAD за 5 дні(-в)
(0 відгуків(и))
0.0