Hello,
I have a program (updater) with which I can update FPGA configuartion data and NIOS II program (application). When I update the application I only see that the FPGA configuration is working ok but the NIOS II program is not running. I am looking for somebody who can have a look at both my programs (updater and application) and help me to make the application NIOS II program work and run on the FPGA. Please send me your bids and convince me that you are the right person for this project. I have added both the updater and application to this project.
Hi,
I have about 17 years experience in FPGA and Embedded Hardware design. I have done logic design for Altera and Xilinx FPGAs. Also have used NIOS II and Microblaze in my designs.
I have not gone through the code but would like to have a better understanding of the setup before that...
1. From my understanding, you are using Master Serial interface for FPGA configuration and using ASMI interface for updating FPGA configuration file?
2. Where is the code for NIOS II stored? Is it external parallel flash or the Serial configuration chip itself is used?
3. Is the NIOS II RAM implemented using Block Memory or External SRAM/SDR/DDR memory used?
Regards
Vinod
i have did a simalar project using nios ii processor. my project is about edge detection in gray scale images by applying to them a filtring using sobel mask