Design me a Product X10 protocol -- 2

Hi i can help you , not problem with your proyect, working with RF433 , and X10 or any other PLC ( power line Control ) see portfolio for samples of works.

previously discussed about this project . expert with Embedded system design Electronic Engineer

Hi, We are a team of electronics engineer with more than 10 years of experience in designing and developing various digital and embedded systems... Since we help engineering students to complete their academic projects, we have experienced with a lot of sensors, components, PCBs etc. Please check our completed projects...:-) Kindly let us know more details about this project and we can complete it together...:-) Thank You

Recently I worked on a RFM22B TX/RX modules that was sent to Spain to control the illumination of a pedestrian crossing. The electronics was connected to a motion sensor on each side of the lanes. When any of the motion sensors detect a pedestrian, the lights start blinking and a message is sent to the other pole to inform that its light must blink as well. The blinking of both lights is synchronized. In this project I used 2 RFM22B, 2 electronic board with PIC24FJ128GA310 with a boot loader and a power mosfet to driver the lights, 2 motion sensors. The system is powered by a solar panel and a 12V battery. The light intensity is controlled via PWM and adjusted based on a LDR. Besides that, I have a complete solution that was applied in the Chuck Pezoldt Park in Miami. This project uses xbee protocol and a gateway DIGI X4 Connectport. The communication to the gateway is made via GSM. I have to know what you have already done in this project in order to complete the project, so, I would like to invite You to discuss the details of the project. We can talk via skype or exchange emails. Only after that I can estimate the schedule to have the project completed. Best regards Antonio Leite