lcd interface board

€30-250 EUR

В роботі

Опублікований

over 5 years ago

€30-250 EUR

Оплачується при отриманні

We have an LCD with an LVDS interface that we want to drive from an ARM board with 24-bit parallel LCD interface. The board runs on 3.3V for logic levels and power supply. The display uses offset voltages of +20V, -6.8V, +11V that need to be generated. The backlight consists of on string of LEDs that need to be driven at 9.6V with 160-180mA. The parallel RGB input comes from a 40 pin, 0.5mm pitch FPC with typical control signals, the LVDS ouput is another 40pin0.5mm pitch connector. The full LCD datasheet is available if you're interested in this project. A number of components that might be used: * [login to view URL] for the lvds conversion * [login to view URL] for voltage generation plus an LED driver chip. Outcome of the project would be either a Kicad or Eagle project with component library plus the corresponding Gerber files.

Circuit Design

Electrical Engineering

Electronics

PCB Layout

ID проекту: 17896782

Про проект

4 пропозицій(-ї)

Дистанційний проект

Активність 6 yrs ago

Хочете заробити?

Переваги подання заявок на Freelancer

Вкажіть свій бюджет та терміни

Отримайте гроші за свою роботу

Опишіть свою пропозицію

Реєстрація та подання заявок у проекти є безкоштовними

4 фрілансерів(-и) готові виконати цю роботу у середньому за €105 EUR

@amelectronics

Hello sir, I have experience in designing electronics circuits and can make your project. i will make your project completely on my side and will deliver a working prototype. I can also develop hardware compatible android and windows based apps. I can show you my previous experience on similar projects. If you wish we can discuss in chat. Thanks

€200 EUR за 10 дні(-в)

4,8

(72 відгуки(-ів))

7,2

@MUhammadt429i

I have long experience with PCB design. I have worked with low-speed , high-speed and power boards. I use Altium Designer and Eagle, and I deliver neat layout that conforms to your dimension constraints and the manufacturing constraints. Regarding your project , I have worked with many LCD modules . Your specifications is very similar to the LQ043T1DG03 LCD of PSP (Play Station Portable). I worked with the LCD before and I could derive the required main components in BOM list. More to be discussed once you contact me . BR, M.T.

€34 EUR за 3 дні(-в)

4,8

(37 відгуки(-ів))

6,0

@hayat38402

I'm embedded software engineer graduated from faculty of engineering department computer and control system. I work on a lot of projects using different micro-controllers like Arduino, Pic 18f452 and Pic 16f877A etc. So I think that I would be the best one doing that job for you on the shortest time, may be done your job before deadline with the same efficiency.

€155 EUR за 3 дні(-в)