PCB Design

$30-250 AUD

Закрито

Опублікований

over 5 years ago

$30-250 AUD

Оплачується при отриманні

Hi All, I'm looking to work with someone to design a PCB board for a GPS Module and suggest potential components. The module will be battery powered ( Not LiPo), need to have low power consumption, be able to run some code (max memory approx 20,000 bytes). It will work with a Tri-Band LTE-FDD and Dual-Band GPRS/EDGE module solution, most likely the 7000 series. The outcome for this project will be: One page of potential components with possible suppliers with pros / cons of each component PCB Design and revisions (This can be capped if necessary). I look forward to viewing your proposals. Regards, Trent and Natha

Circuit Design

Electrical Engineering

Electronics

PCB Layout

Product Design

ID проекту: 18000748

Про проект

5 пропозицій(-ї)

Дистанційний проект

Активність 5 yrs ago

Хочете заробити?

Переваги подання заявок на Freelancer

Вкажіть свій бюджет та терміни

Отримайте гроші за свою роботу

Опишіть свою пропозицію

Реєстрація та подання заявок у проекти є безкоштовними

5 фрілансерів(-и) готові виконати цю роботу у середньому за $193 AUD

@Euroaccount

Hello How are you? I am an expert in PCB design with more than 7 years of experience and I have rich experience in developing GPS tracking device and PCB design. So I am sure that your project is the best match for my skills and experience and I will give you the best result . Thanks.

$155 AUD за 3 дні(-в)

4,9

(26 відгуки(-ів))

7,3

@KartikSheladiya

Hello there, Greetings!!!! I am from Ahmedabad, Gujrat and I have already developed GPS device and can share you PCB design and BOM for the same, also I can send you a sample(at minimal cost) if you want. Do visit my portfolio to see the design Regards, Kartik Sheladiya

$500 AUD за 3 дні(-в)