Hello sir/ma, I'm interested in taking this task up for you. I am an Electrical Engineer with a masters degree and I have high proficiency knowledge in
FIRMWARE:
FPGA firmware in VHDL and Verilog for Altera/Actel/Xilinx FPGAs and EEG signal
MCU firmware in C/C++ for ARM, TI, NXP, Atmel, PIC, embedded RFID
Bluetooth, Bluetooth Low Energy (BLE), and wireless modules programming,, GPS modules, Temperature, Pressure sensors, Metal Detectors, motor drivers, 12V, 24V DC motors, Servo Motors, HC-05 Bluetooth
HARDWARE:
Schematic capture: Digital, Analog, Power electronics. EDA: Altium Designer.
PCB Layout: Altium Designer, 1 - 10 layers;
Component selection, BOM generation, Gerber generation, HVAC, LTE system model, Thermal system design, Matlab/ Simulink, Microcontroller, Modeling, optimization, simulation of building energy systems, Arduino and have been working on Industrial Automatics, Prototyping, PCB Design, Development of Electronic systems. Once you share the project, I will have a look & confirm if I can do it. I’m honest, creative and a unique person to carry out your tasks given to me. Leaving your project on our hand is privileged; we'll make sure that the project is done in a perfect way and do our best until you were satisfied. I would love to discuss this project with you and meet your exact requirements. I am confident I can provide you with top-notch materials that will fit your needs. I pride my work on being professional