Read Modbus data with a raspbverry PI

€30-250 EUR

В роботі

Опублікований

over 3 years ago

€30-250 EUR

Оплачується при отриманні

I have a heat-pump and I can't monitor it from outside, it has only one small remote display. I was able to identify what is the communication method between Heat-pump and remote with a logic analyser, picture attached. So what I need is: mode, state, compressor frequency, current consumption, compressor run time, compressor pressure, fan speed, and few temperatures. Also, I would like to be able to configure some parameters, but that's the second step.

Raspberry Pi

ID проекту: 27860781

Про проект

4 пропозицій(-ї)

Дистанційний проект

Активність 4 yrs ago

Хочете заробити?

Переваги подання заявок на Freelancer

Вкажіть свій бюджет та терміни

Отримайте гроші за свою роботу

Опишіть свою пропозицію

Реєстрація та подання заявок у проекти є безкоштовними

Доручений:

@akshayharikumar

Thank you for this opportunity to bid. I will be able to assist you here, since I have worked on interfacing Modbus-over-RTU for quite a few projects, to read information from smart meters and data loggers for example. I shall advice you on the hardware requirements, as well as share the reliable, working code with you, including the libraries to be installed, and the documentation. I would need the following information from you to get started: MODBUS default device ID of the heat pump, and the register addresses of the required data.

€167 EUR за 5 дні(-в)

0,0

(0 відгуки(-ів))

0,0

4 фрілансерів(-и) готові виконати цю роботу у середньому за €222 EUR

@sherifshsffa91

I am excellent at the following : - raspberry pi - Linux - python - communication (mqtt, http, i2c, uart and spi) i can deliver your project efficiently at time. i can work on a similar product whoch uses modbus protocol then implement your solution then deliver it to your own raspberry pi then you test it. if you choose me, I think you won't regret. best regards,

€222 EUR за 7 дні(-в)

5,0

(11 відгуки(-ів))

5,8

@Provi11

I have 3 years experience in Iot and embedded systems and have good hands on both hardware and software. I have worked on many projects that are as follows: Raspberry pi projects with Python and C Servo motor control through touch screen panel Arduino based projects Raspberry pi based projects Smart lock based on esp8266 Smart water management system based on esp8266 and AWS server Smart energy meter solution Smart curtain controller all the above are based on esp8266 and AWS server i have also worked on electric vehicle and implemented internet of things concept there too. we just need your patience and my hardwork. looking forward to work with you regards Prashant Mishra

€200 EUR за 7 дні(-в)